Red Luminous Single Pole Switch 16A 250V Standard
Red Bipolar Switch, With Pilot Light.
Voltage: 16(4)A 250V.
Max. Temperature 120°C
Drilling Template 11X30 Mm
Comparable Models: Cookmax, Roller Grill. C.O. A0712

Advertising [ProductAdditionalInfo]
local_shipping FREE shipping on orders over $25.00 shipped by Amazon. Details
Red Bipolar Switch, With Pilot Light. Voltage: 16(4)A 250V. Max. Temperature 120°C Drilling Template 11X30 Mm Comparable Models: Cookmax, Roller Grill. C.O. A0712
Change Swich Dishwasher Button
Disconnect The Power Supply To The Bosch Dishwasher By Turning The Main Switch To "No" In The Electrical©Switch Box. Open The Dishwasher Door And Locate The Torx Screws Along The Top Of The Dishwasher Door To Allow Access To The Control Panel. Loosen The Two Screws On The Top Of The Door And The Two Screws On The Side Of The Top Panel. Use A Torx Screwdriver To Remove The Screws. Lift The Door As If You Were Closing And Then Lift The Control Panel Cover And Pull It Out Of The Door. It Will Not Separate Completely While The Cables Are Still Connected. Disconnect The Cables And Tape That Goes To The Control Console Board By Pulling Them Out Of The Console. The Control Console Dashboard Runs The Length Of The Dishwasher And Includes The Buttons And The Plate Control Panel. Press The Tabs On The Sides Of The Control Console Plate With A Flathead Screwdriver. ? Pull The Control Console Plate Out Of The Door. Insert The New Control Console Plate And Push Down Until The Tabs Snap Into Place. Reconnect The Cables And Tape From The Dishwasher, Pushing Back Into Place. Reverse The Steps To Screw The Control Console Plate Into Place On The Dishwasher Door. Compatible With: Roller Grill Hot Exposer Bmv 2, Bmv 3, Wd 100, Wd 200, Wdl 100, Wdl 200 Roller Grill Pizza Oven Pz 330, Pz 400, Pz 660
LF3319969

feedback Report comment