Single pole illuminated red switch 16A 250v Standard

Bipolar red switch with pilot light. Voltage: 16(4)A 250V. max. temperature 120°C Drilling template 11x30 mm Compatible models: COOKMAX, ROLLER GRILL. C.O. A0712

CHANGE DISHWASHER SWITCH BUTTON

Disconnect power to the Bosch dishwasher by switching the main switch to "No" in the electrical breaker box. Open the dishwasher door and locate the Torx screws along the top of the dishwasher door to allow access to the control panel. Loosen the two screws at the top of the door and the two screws on the side of the upper panel. Use a Torx screwdriver to remove the screws. Lift the door as if closing it and then lift the control panel cover and pull it out of the door. It will not separate completely while cables are still connected. Disconnect the cables and ribbon going to the control console board by pulling them out of the console. The control console board runs along the dishwasher and includes the buttons and control panel board. Press the tabs located on the sides of the control console board with a flat head screwdriver. Pull the control console board out of the door. Insert the new control console board and push down until the tabs snap into place. Reconnect the cables and ribbon of the dishwasher, pushing them back in place. Reverse the steps to screw the control console board in place on the dishwasher door. COMPATIBLE WITH: ROLLER GRILL Hot display BMV 2, BMV 3, WD 100, WD 200, WDL 100, WDL 200 ROLLER GRILL Pizza oven PZ 330, PZ 400, PZ 660