Bosch 3Ts759 17 610147 Washing Machine Door Lock Delay

Example Of A Label Where To Find The Model Of A Device Newpool Check Challenged Doorto Check A Door Lock We Will Have To Have A Polymeter. Know That It Is A Switch With Two Wires, One Input And One Output And That They Are Normally Numbered As C And N And Together With A Third Wire That Is Marked With F.De In This Way What We Do When We Start Our Washing Machine Is To Put Current Between F And N Phase And Neutral To A Ptc Resistor That Causes A Bimetal To Heat Up And Trip, Closing The Circuit Between N And C In This Way We Already Have The Switch Closedâ Letting Current Pass Through And Our Washing Machine Starts Up. At The Same Time This Has Happened And When The Bimetal Is Fired, It Has Moved Like A Small ±Bolt That Now Prevents Our Washing Machine From Opening. In This Way We Have Achieved A Safety System That Will Not Allow The Door To Open While The Washing Machine Is Running, Avoiding Accidents. When The Washing Machine Finishes Washing, The Terminals F And N Stop Getting Current, This Bimetal Cools After A Few Seconds, Returns To Its Natural Position And The Bolt Unlocks Listening To A Clip And From Now On We Can Open The Door. Never Try It Before As We Will Break The Handle Or Latch Of The Door. To Check This Piece We Must Prepare A Cable With Two Insulated Terminals (Faston) And Put Current Between F And N, Move The Sliding Part Of The Lock To Let The Bolt We Were Talking About Come Out And After A Few Seconds With The Help Of A Measuring Device, Placed In Ohm Measurement We Can Check If It Gives Us Passage Between N And C, If So Our Piece Will Be Working Well, Otherwise We Will Have To Replace.